Questions? Call us at (262) 218-2915

Sign Regulations in Worth, Illinois

Worth, Illinois has specific sign regulations covering 34 sign types across 4 zoning districts. Regulated sign types include Temporary Window Sign, Yard Sign, Awning Sign. Height restrictions apply. Permits are required for most commercial signs. Use PermitPal to get instant access to the complete regulations.

Data last verified: April 20, 2025

Need the sign code for this address?

PermitPal is an independent research tool for sign companies. We are not the city's permit office.

Sign Regulation Overview for Worth, Illinois

Sample Sign Requirements in Worth

Sign TypeMax HeightMax AreaSetback
Canopy-Mounted Sign2 ft (measured from top of canopy)1 sq ft per linear ft of building facadeNot listed
Marquee Sign8 ft (includes all letters, logos, representations)Not listedNot listed
Drive-Thru Sign7 ft100 sq ftMin 15 ft from residential lot line

* Sample data shown. Actual requirements may vary by zone. Use PermitPal for complete, location-specific regulations.

PermitPal Coverage for WorthFull Coverage

Sign Types Covered

34

  • Temporary Window Sign
  • Yard Sign
  • Awning Sign
  • Canopy-Mounted Sign
  • +2 more types

Zoning Districts

4

Different zoning districts with specific sign regulations

Data Includes

  • Permit requirements
  • Height restrictions
  • Illumination rules

Frequently Asked Questions

In Worth, the height limit for Monument Sign in the B1 District, B2 District, M1 District, M2 District, PUD District is 12 ft (Sec. 4-4-5(B)(5)). Maximum sign heights range from 6 ft to 20 ft across zoning districts. Other zones and sign types can have different limits. Run a code check for an exact address to see the limit that applies there.

Most commercial signs in Worth require a permit. From the submission notes on this page: There is no explicit requirement for a master sign plan or sign plan for all zones in the provided ordinance text. Run a code check for an exact address to see the permit requirements for that zone.

Worth's sign code covers 34 sign types, including Temporary Window Sign, Yard Sign, Awning Sign, and Canopy-Mounted Sign. Most commercial signs need a permit. The ordinance lists 11 exemptions. One of them: Flags do not require a permit and are allowed in all zoning districts if they comply with code standards. The full list is on this page.

In Worth, Monument Sign (Residential Development Identification & Non-Residential Uses) in the Residential Districts must be set back 5 ft from front/corner side, 10 ft from interior side (Sec. 4-4-5(B)(5)). Setbacks for other zones and sign types can differ. Run a code check for an exact address to see the setback that applies there.

Rules in Worth's sign ordinance that cover digital, changing, or flashing signs: Flashing Signs are prohibited. Moving Signs are prohibited. No sign or other advertising device shall have moving, revolving, or rotating parts. (This prohibition does not include barber poles, electronic message signs, flags, pennant signs, street clocks, and other signs as established by this Section.). Video Display Signs are prohibited. Run a code check for an exact address to see the full illumination rules for that zone.

AI-Powered Research

Ready to Research Worth Sign Permits?

Stop spending hours searching through municipal codes. Enter your address and PermitPal returns the sign rules that apply to your property in Worth, Illinois, with citations from the municipal code.

Need the sign code for this address?

PermitPal is an independent research tool for sign companies. We are not the city's permit office.

No credit card required · Get results in seconds

Worth, Illinois Sign Rules at a Glance

Worth, Illinois regulates 34 sign types across 4 zoning districts. Drive-Thru Signs in the B1 District, B2 District, M1 District, M2 District, PUD District are capped at 7 ft tall and 100 sq ft, set back at least 15 ft from residential lot line (Sec. 4-4-5(B)(4)). Most commercial signs in Worth require a permit.

Detailed Sign Ordinance Requirements for Worth, Illinois

Sign Rules by Zoning District in Worth (4 zones)

Zoning DistrictSign Types RegulatedMax HeightMax AreaPermit Required
B1 District, B2 District, M1 District, M2 District, PUD District1315 ft150 sq ftNot listed
Residential Districts86 ft80% of host sign areaNot listed
Non-residential Districts620 ft32 sq ftNot listed
General Regulations For All Zones9Not listed6 sq ftNot listed

Zone-by-Zone Sign Requirements in Worth(sample of 3 of 4 zones)

B1 District, B2 District, M1 District, M2 District, PUD District

Sign TypeMax HeightMax AreaMax WidthSetbackSigns AllowedLocationPermit RequiredPremium Details(Illumination, Size Formula, Permit Requirements, Additional Requirements, available with a free PermitPal account)Ordinance Citation
Canopy-Mounted Sign2 ft (measured from top of canopy)1 sq ft per linear ft of building facadeNot listedNot listed1 per tenant entranceOn canopy projecting from any facade up to 6 feet; canopy at least 7 feet above grade and sign not below canopy's lowest point.Not listedUnlock4-4-5(B)(2)
Marquee Sign8 ft (includes all letters, logos, representations)Not listedNot listedNot listed1 per frontage containing primary tenant entranceCan project from front or corner side facade; not beyond curb line; at least 1 ft from edges of facade (unless wraparound); at least 8 ft above grade; supported solely by building.Not listedUnlock4-4-5(B)(3)
Drive-Thru Sign7 ft100 sq ftNot listedMin 15 ft from residential lot line2 per drive-thru laneAllowed for drive-thru establishments; at least 15 ft from residential lot line.Not listedUnlock4-4-5(B)(4)
Monument Sign12 ft75 sq ftNot listedMin 5 ft front/corner side, 10 ft interior side1 per street frontage (<300 ft lot width); 2 per street frontage (≥300 ft lot width)Allowed for any use; must be at least 5 ft from front/corner side lot line and 10 ft from interior side lot line.Not listedUnlock4-4-5(B)(5)
Projecting Sign6 ft24 sq ftNot listedNot listed1 per street frontage per ground floor tenantAt least 7 ft above grade; can project up to 6 ft from building; not above roof; not within 2 ft of curb; all supports attached to facadeNot listedUnlock4-4-5(B)(6)
Wall Sign (Front/Corner Side Façade)Not listed1.5 sq ft per linear ft (≥40 sq ft)Not listedNot listed1 per street frontage per tenantOn façade, not more than 1 ft projection, not above top of wall, generally uniform height across development.Not listedUnlock4-4-5(B)(7)
Wall Sign (Side/Rear Façade)Not listed1 sq ft per linear ftNot listedNot listed1 additional per tenantSide or rear façade of building.Not listedUnlock4-4-5(B)(7)
Electronic Message SignNot listed50% of host sign areaNot listedNot within 500 ft of another electronic message sign1 per lotOnly as part of marquee or monument sign; not within 500 ft of another electronic message sign property line (by roadway). Allowed only in B1, B2, PUD.Not listedUnlock4-4-5(B)(9)

Residential Districts

Sign TypeMax HeightMax AreaMax WidthSetbackSigns AllowedLocationPermit RequiredPremium Details(Illumination, Size Formula, Permit Requirements, Additional Requirements, available with a free PermitPal account)Ordinance Citation
Awning Sign (Non-Residential & Multi-Unit Use)Not listedNot listedNot listedNot listedNot listedMay project from any facade, up to 6 ft; at least 7 ft above grade; not project higher/lower than awning points; not within 2 ft of curb; awnings may project over lot line.Not listedUnlock4-4-5(B)(1)
Canopy-Mounted Sign (Non-Residential & Multi-Unit Use)2 ft (from top of canopy)1 sq ft per linear ft of building facadeNot listedNot listed1 per tenant entranceCanopy must be at least 7 ft above grade, not project below; attach to any facade up to 6 ft.Not listedUnlock4-4-5(B)(2)
Monument Sign (Residential Development Identification & Non-Residential Uses)6 ft40 sq ftNot listed5 ft from front/corner side, 10 ft from interior side1 per street frontage (<300 ft lot width); 2 per street frontage (≥300 ft lot width, 100 ft apart)At least 5 ft from front/corner side lot, 10 ft from interior sideNot listedUnlock4-4-5(B)(5)
Wall Sign (Non-Residential & Multi-Unit Use)Not listed1.5 sq ft per linear ft (≥40 sq ft) front; 1 sq ft per linear ft rear/interiorNot listedNot listed1 per street frontage per tenant; 1 additional side/rearWall of building as per general standardsNot listedUnlock4-4-5(B)(7)
Window Sign (Non-Residential & Multi-Unit Use)Not listed25% of window areaNot listedNot listedNot listedOn/in windowNot listedUnlock4-4-5(B)(8)
Manually Changeable Copy Sign (Non-Residential Use)Not listed80% of host sign areaNot listedNot listed1 per lotAs component of marquee, monument, pole, or wall sign.Not listedUnlock4-4-5(B)(10)
Temporary Window SignNot listed25% of window areaNot listedNot listedNot listedOn/in windowNot listedUnlock4-4-6(B)(1)
Yard Sign6 ft6 sq ftNot listedNot listed2 per frontage plus 1 per qualifying condition per frontageAny yard in residential districtsNot listedUnlock4-4-6(B)(2)(A)(i)

Non-residential Districts

Sign TypeMax HeightMax AreaMax WidthSetbackSigns AllowedLocationPermit RequiredPremium Details(Illumination, Size Formula, Permit Requirements, Additional Requirements, available with a free PermitPal account)Ordinance Citation
A-Frame Sign4 ft8 sq ftNot listedNot listed1 per businessOn sidewalk; at least 4 ft of sidewalk width must remain; must be within 15 ft of primary business entrance.Not listedUnlock4-4-6(C)(1)
Banner Sign, TemporaryNot listed32 sq ftNot listedNot listed2 per businessAffixed to railing, fence, or accessory building (not to principal structure); cannot encroach public right-of-way.Not listedUnlock4-4-6(C)(2)
Banner Flag Sign15 ftNot listed3 ftNot listed1 per 50 ft of property frontageNot in any setback or vehicle/pedestrian passageway. Not in ROW.Not listedUnlock4-4-6(C)(4)
Inflatable Device20 ftNot listedNot listedNot listed1 per businessNot in setback, veh. or ped. passage, or public ROW.Not listedUnlock4-4-6(C)(3)
Temporary Window SignNot listed25% of window areaNot listedNot listedNot listedOn/in windowNot listedUnlock4-4-6(B)(1)
Yard Sign8 ft20 sq ftNot listedNot listed2 per frontage plus 1 per qualifying condition per frontageAny yard in non-residential districtsNot listedUnlock4-4-6(B)(2)(A)(ii)

PermitPal covers all 4 zoning districts in Worth. Run a code check for your exact address to get the zone that applies to your property and its full sign requirements with a free account: illumination rules, size formulas, and permit requirements for every sign type.

Run a free code check

Prohibited Signs in Worth

  • Attention Getting Devices are prohibited.
  • Bandit Signs are prohibited.
  • Flashing Signs are prohibited.
  • Moving Signs are prohibited. No sign or other advertising device shall have moving, revolving, or rotating parts. (This prohibition does not include barber poles, electronic message signs, flags, pennant signs, street clocks, and other signs as established by this Section.)
  • Obscene Signs are prohibited.
  • Portable Signs are prohibited.
  • Roof Signs are prohibited.
  • Vehicle Signs are prohibited.
  • Video Display Signs are prohibited.
  • Signs (or advertising devices) that interfere with, obstruct the view of, or are confused with any traffic sign, signal, or device because of position, shape, illumination, or color are prohibited.
  • Signs may only be placed on public property by a government agency or as authorized by this Section. Any sign placed on public property without authorization may be removed without notice.
  • Signs may only be placed on private property with prior consent of the property owner and, if applicable, a permit issued by the Village.
  • A sign mounted on the exterior of a building shall not conceal any windows, doors, or unique architectural features (except for window signs).
  • No sign may be constructed, erected, or maintained in a manner that is unsafe, insecure, or a danger to the public.
  • All sign illumination must be located, shielded, and directed to illuminate only the sign face and prevent direct light or glare on adjacent rights-of-way and properties. No sign illumination may be combined with reflective materials such as mirrors, polished metal, or highly-glazed tiles to increase glare.

Exempt Signs in Worth

  • Flags do not require a permit and are allowed in all zoning districts if they comply with code standards.
  • Government Signs do not require a permit and are allowed in all zoning districts if they comply with code standards.
  • Headstones do not require a permit and are allowed in all zoning districts if they comply with code standards.
  • Historical Markers do not require a permit and are allowed in all zoning districts with material and size limitations.
  • Parking Lot Driveway Signs do not require a permit and are allowed in all zoning districts with quantity standards.
  • Parking Lot Signs do not require a permit and are allowed in all zoning districts with area limitation.
  • Street Address Signs do not require a permit and are allowed in all zoning districts if not internally illuminated and within size limits.
  • Warning Signs do not require a permit and are allowed in all zoning districts.
  • Wayfinding signs do not require a permit and are allowed in all zoning districts.
  • Temporary Window Signs do not require a permit and are allowed in all zoning districts if within area and display period limits.
  • Yard Signs do not require a permit and are allowed in all zoning districts if within area, height, and quantity limits.

Sign Plan & Submission Notes for Worth

  • There is no explicit requirement for a master sign plan or sign plan for all zones in the provided ordinance text.
  • A permit is required for certain types of permanent and temporary signs as outlined in Sections 4-4-5 and 4-4-6.
  • Signs erected on private property may require a permit issued by the Village.
  • There is no mention of a required sign variance meeting for general signage (such requirements may exist for special situations not included in this excerpt).